Up
|
What you are purchasing is a high quality Target 230/460 volt 20" 7.5hp three-phase Guardmatic block saw. This unit has an electric motor which operates on a run-and-start capacitor. There are only two pivot points for reduced saw maintenance and longer diamond blade life. Sealed lifetime lubricated bearings - no greasing required! The spring tension counter-balanced cutting head, making raising and lowering easy and the cutting head height can be controlled with a convenient crank control and foot pedal. The open throat design allows passage of large pieces of materials to be cut. It has a field installable blade shaft assembly and the electric water pump is self-priming and thermally protected- it provides consistent water delivery for maximum blade protection. The brass water tubes are built into either side of the guard for long life and easy service. The large conveyor cart is a durable, cast aluminum cart for strength and rigidity and is 16-5/8" long x 22-3/4" wide and it's included. The vulcanized rubber top is permanently bonded to the cart and has a durable ruler for quick, easy measurements. The included aluminum rip guide assures straight cuts. * Large conveyor cart included NOTE: Commercial Addresses constitute as areas zoned as COMMERCIAL and INDUSTRIAL. If you operate your business out of your home, that is NOT considered a commercial address!!! For residential deliveries please add $100.00. NO SALES TAX IN: ALABAMA, ALASKA, ARKANSAS, COLORADO, DELAWARE, FLORIDA, GEORGIA, IDAHO, ILLINOIS, INDIANA, KANSAS, MICHIGAN, MINNESOTA, MISSOURI, MONTANA, NEW HAMPSHIRE, NEW JERSEY, NEW MEXICO, NEW YORK, NORTH CAROLINA, NORTH DAKOTA, OHIO, OKLAHOMA, OREGON, TEXAS, UTAH, VERMONT, VIRGINIA, WASHINGTON, WASHINGTON D.C., WEST VIRGINIA, WYOMING DeFusco Industrial Supply |