SESCO 30,000 LBS X 60" X .200" COMBINATION COIL CRADLE/STRAIGHTENER/SERVO FEEDER* Capacity (Max.): 60" x .200"; 16" x .413" Minimum Coil Thickness Capacity: 60" x .060" Maximum Coil Weight Capacity: 30,000 Lbs. Maximum Coil Outside Diameter: 72" Coil Width: 4" - 60" (7) Powered & Backed Up Straightener Rolls: 5-5/8" Diameter Set of Input Threading Rolls: 8" Diameter Set of Feed Rolls: 8" Diameter Feed Rate: Variable Feed Length (Programmable): 0" - 99.998" Feed Direction: Left to Right Adjustable Upper Straightener Rolls Motorized Individual Coil Guide Plates Adjustment Adjustable Pass Line Height (Power Elevation): 63" +/-4" EQUIPPED WITH: Allen Bradley A.C. Vector Drive w/Panel View 550 Pneumatic Lift to Upper Rolls Hydraulic Adjustment to Threading Rolls Combination Coil Stop-Peeler-Threading Assist-Dekinker Unit Sesco Traversing Coil Storage Ramp Automatic Stroke to Stroke Material Edge Guiding 150 HP DC Main Drive Motor 480/3/60 Trabon Automatic Lubricating System Electrical Controls (Free Standing Cabinet) Approximate Overall Dimensions: Approximate Weight: Serial Number: 23478 (New 1998) P2 F.O.B. WAREHOUSE,SAN JOSE, CA - $225,000.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |