Up
|
For More information on this item, contact us at: Hypertherm PowerMax 1250 Plasma Cutter The Powermax1250 is the first of the Powermax G3 Series. With new technologies in both power supply and torch, it cuts faster and more economically than any system available today. In fact, it cuts 80% faster on 1-inch (25 mm) mild steel than any competitor tested. Its Auto-voltage™ circuit provides automatic adjustment to any input voltage from 200 to 600 volts, 1- or 3-phase. A state-of-the-art, microprocessor-based architecture assures optimum system Recommended capacity: metals to 7/8 inch (22 mm) at cutting speeds over 20 inches (500 mm) per minute. 1 1/8 inch (29 mm) at cutting speeds over 10 inches (250 mm) per minute. Severance capacity: rough cut on metals up to 1 1/2 inches (38 mm) at Advanced, intelligent technology gives the Powermax1250 the power to cut with greater speed, quality and efficiency. 80-amp, 12-kilowatt output provides ample power for clean, quick cutting. Auto-voltage runs on voltages from 200 to 600 volts, 1- or 3-phase, without New Boost Conditioner™ circuit compensates for input voltage variation. Advanced, digitally-controlled inverter design delivers continuously adjustable, constant current output, from 25 to 80 amps, permitting high-quality cuts over a wide range of metal thicknesses. An active electronic pilot arc controller for cutting expanded metal or grating. New gouging setting allows for improved arc transfer, easier operation and faster is standard on all units, allowing automated control and rapid change Construction and structural fabrication Work cable with clamp15 feet (4.5 m) *Maximum travel speeds are the results of Hypertherm's laboratory testing. For optimum cut quality, speeds should be reduced between 35 – 50%, depending upon the material. Refer to your operators manual for more detail. **Estimated 200 – 600 V, 1- or 3-PH, 50/60 Hz, CSA 230 – 400 V, 3-PH, 50/60 Hz, CE 200/208/230/240/480 V, 1-PH: 70/70/60/58/31 A 200/208/230/240/400/480/600 V, 3-PH: 41/40/37/34/21/17/17 A Output Current Adjustable, 25 to 80 amps 60% @ 80 A, 230 – 600 V, 3-PH 50% @ 80 A, 200 – 208 V, 3-PH 40% @ 80 A, 200 – 208 V, 1-PH 23.1" (586 mm) D; 10.65" (271 mm) W; Weight with Torch 96.6 lbs (44 kg) Gas Supply Clean, dry, oil-free air Flow Rate 400 scfh; 6.7 cfm (189 l/min) at 90 psi (6.2 bar) 70 psi (4.8 bar) flowing, 25' leads 75 psi (5.1 bar) flowing, 50' leads If you have questions, call Sue at . Information about our company is also available on our website. |