New hypertherm powermax 1000 plasma cutter

UpUp


Subject: New hypertherm powermax 1000 plasma cutter
For More information on this item, contact us at:
Hypertherm PowerMax 1000 Plasma Cutter
Recommended capacity: metals to
3/4 inch (19 mm) at cutting speeds
over 20 inches (500 mm) per minute.
1 inch (25 mm) at cutting speeds
over 10 inches (250 mm) per minute.
Severance capacity: rough cut on
metals up to 1 1/4 inches (32 mm) at
60-amp, 8.4-kilowatt output provides
ample power for clean, quick cutting.
Auto-voltage runs on voltages from
200 to 600 volts, 1- or 3-phase,
(CE 230 to 400 V 3-phase only)
without the need for manual rewiring.
New Boost Conditionerâ„¢ circuit
compensates for input voltage variation.
Advanced, digitally-controlled inverter
design delivers continuously adjustable,
constant current output, from 20 to
60 amps, permitting high-quality cuts
over a wide range of metal thicknesses.
An active electronic pilot arc controller
for cutting expanded metal or grating.
New gouging setting allows for improved
arc transfer, easier operation and faster
is standard on all units, allowing
automated control and rapid change
Construction and structural fabrication
*Travel speeds are approximately 80% of maximum.
200 600 V, 1/3-PH, 50 60 Hz, CSA
230 400 V, 3-PH, 50 60 Hz, CE
200/208/230/240/480 V, 1-PH: 50/48/44/42/22 A 200/208/230/240/400/480/600 V, 3-PH: 30/29/26/24/15/12/11 A
Output Current Adjustable, 30-80 A
50% @ 60 A, 230 600 V, 3-PH
50% @ 60 A, 230 480 V, 1-PH
40% @ 60 A, 200 208 V, 3-PH
40% @ 60 A, 200 208 V, 3-PH
23.1" (586 mm) D; 10.7" (271 mm) W;
Weight with Torch 83 lbs (37 kg)
Gas Supply Clean, dry, oil-free air
Flow Rate 400 scfh; 6.7 cfm (189 l/min) at 90 psi (6.2 bar)
70 psi (4.8 bar) flowing, 25' leads
75 psi (5.1 bar) flowing, 50' leads
If you have questions, call . Information about our company is also available on our website www.weilerdirect.com.
Try Andale Gallery. Now with Brand New Themes.