Up
|
TECNOPRES MODEL KZP 20S HYDRAULIC, 4-POST, DOWN-ACTING TRIM PRESS Capacity: 20 Ton Return (Pulling) Capacity: 4.5 Ton (Approx) Stroke: 19.7" (Maximum) Daylight: 40.6" (Over Bed); 35.4" (Over Shuttle Table) Nominal Die Space: 27.5" L-R x 47.5" F-B Overall Area of Upper & Lower Platens: 37.5" L-R x 47.25" F-B Distance Between Posts: 27.5" L-R x 37.5" F-B Cylinder Diameter: 4.25" Tie Rod Diameter: 3" Distance Bed to Floor: 30.5" Speeds: 1181 IPM - Advance 128 IPM - Press 567 IPM - Return EQUIPPED WITH: Shuttle Table (35.5" x 33.5" x 5"; 36" Stroke) T-Slotted Bed & Ram (2) Hydraulic Ejectors in Ram Tonnage Adjustment with Gauge Stroke Limit Control Automatic Lubrication System 17 HP AC Main (Pump) Drive Motor Electrical Controls (Seperate, Free-Standing Panel) Dual Push Button Operation Water Cooled Heat Exchanger Approximate Overall Dimensions: 130" L-R x 66" F-B x 136" H Approximate Weight: 9,000 Lbs.(ELECT PANEL: 33"X20"X80") Serial Number: 2622 (New 1993) P2 F.O.B. Elk Grove, IL - $ 9,500.00 Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |