Up
|
PINES MODEL 5T HYDRAULIC, VERTICAL TUBE BENDER* Capacity: 5 Ton Tube Size Range: Up to 1-1/4" (1 Tube) Centerline Radius Range: (Permitting Bending to Maximum Angle) 3-1/2" Maximum C.L.R.; 2" to 3" Minimum Work Diameter Bend Angle: 100 Degrees Maximum - Normal Tooling Operating Pressure: 2,000 PSI Production Speed: up to 2,000 Bends per Hour Variable Ram Speed Control; Height from Floor to Dies: 40" Welded Steel Bed with Integral Oil Reservoir in Base EQUIPPED WITH: Digital Dial-A-Bend Dual Die Holders; Bijur Automatic Lubricator 20 HP AC Main (Pump) Motor Electrical Controls; P/B Operations (Pedestal Mounted) BENDING CAPACITIES: Non-Ferrous Tubing Y.P. to 25,000 PSI: (2) 1" x .072" Wall Mild Steel Y.P. 40,000 PSI: (2) 1" x .065" Wall Stainless Y.P. 60,000 PSI: (2) 1" x .049" Wall Steel Pipe Schedule 80: (2) 3/8" Square Tube (Mild Steel): (2) 7/8" x .035" Round Bar (Mild Steel): (2) 5/8" Square Bar (Mild Steel): (2) 1/2" Maximum Section Modulus (Mild Steel): 2 @ .036" Maximum Horizontal and Vertical Dimensions: 2" x 1-1/4" Approximate Overall Dimensions: 64" L-R x 87" F-B x 60" H Approximate Weight: 3,000 Lbs. Serial Number: 44362-88064 (New 1988) P2 F.O.B. Elk Grove, IL - $ 24,500.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |