Pines 3T vertical tube bender

UpUp


Subject: Pines 3T vertical tube bender
PINES MODEL 3T HYDRAULIC, VERTICAL TUBE BENDER*
Bending Capacity: 1-1/4" O.D. x .065" Wall (Steel Tubing)
Tube Size Range: up to 1-1/4" O.D.
Centerline Radius Range: (Permitting Bending to Maximum Angle)
3-1/2" Maximum C.L.R.
2" to 3" Minimum Work Diameter
Maximum Bend Angle: 140 Degrees - w/Normal Tooling
165 Degrees - w/Special Tooling
Production Rate: up to 1500 Bends/Hour
Variable Ram Speed Control, 2,000 PSI Operating Pressure
Cycle Time (at 90 Degree Bend): 1.5 Seconds
Welded Steel Bed with Integral 50 Gallon Oil Reservoir in Base
EQUIPPED WITH:
Digital Dial-A-Bend
20 HP AC Main (Pump) Motor
Electrical Controls
BENDING CAPACITIES:
Non-Ferrous Tubing 25,000 PSI: 1-1/4" x .083"
Mild Steel Tubing Y.P. to 40,000 PSI: 1-1/4" x .065"
Stainless Tubing Y.P. to 60,000 PSI: 1-1/4" x .049"
Square Tubing (Mild Steel): 1" x .065"
Round Bar (Mild Steel): 3/4"
Square Bar (Mild Steel): 9/16"
Approximate Overall Dimensions: 80" L-R x 33" F-B x 56" H
Approximate Weight: 3,000 Lbs.
Serial Number: 44361-89134 (New 1989)
P2 F.O.B. Elk Grove, IL - $ 16,500.00
* PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION
Email us at
Call our Sales Staff at
Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes.
Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power.
(outside US & Canada)
Email: