Up
|
ORRI MODEL LCC13HRMAX-MHS SERVO COIL LINE* Material Thickness: .016" - .126" Maximum Coil Weigh: 15,000 Lbs. Material Width Capacity: 2.76 - 51.2" Maximum Coil Outside Diameter: 55" Inside Coil Diameter: 16" - 20" Number of (Powered) Straightener Rolls: 7 Feed Rate (Programmable): 866 IPM Max. Feed Direction: Left to Right Feed Length (Programmable): 19.7" Max. Pass Line Height: 47.2" EQUIPPED WITH: PLC Control; Hydraulic Mandrel Expansion Traveling Coil Car; Hold Down Arm w/Threading Wheel Adjustable Stock Entry Guide Rolls Manual Straightener Rolls Adjust w/Dial Indicators Pneumatic Roll Lift; Threading Table Hydraulic Power Unit 8 HP AC Main (Straightener) Motor 5 HP AC Main (Pump) Motor Programmable Feed Length and Speed Control Electrical Controls; Push Button Operation Approximate Overall Dimensions: 170" L-R x 110" F-B x 90" H Approximate Weight: 15,000 Lbs. Serial Number: 02HR-0034 (New 2002) P2 F.O.B. Elk Grove, IL - $175,000.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |