Up
|
WILTON 10 x 16" HORIZONTAL MITERING BAND SAW Available in: 1-1/2HP 115/230V,1Ph, 2HP,220V, 3Ph, 2HP,440V,3Ph * With Mitering head, workpiece remains fixed while the head swivels to cut any angle from 0 to 45 degrees and locks with a quick acting lever. Photo shown is without Mitering capability. * Equipped with Wilton's exclusive swivel control panel which allows the operator to access controls from the front or back of the machine * Rapid Acting vise for simple, fast, and accurate set up. For standard cut offs, the ridged design makes square cuts easy. This design improves operator safety, allows for faster set up, increases through put, thereby lowering costs per cut. For Mitering no wrenches are needed to set up the vise. The angle can be pre-adjusted by simply loosening a handle. * Standard variable speed drive allows the operator to fine tune the blade speed to maximize the performance. This again results in higher efficiency and lower costs per cut. * 14" dia. cast iron blade wheels * Heavy duty transmission utilizes hardened and ground gears operating in an oil bath. This provides a smooth, quiet drive train and positive SFM to the blade. * The saw is gravity fed but controlled by a dual system of counter-balance springs working with a hydraulic cylinder to ensure smooth, constant feed pressure on the blade. * Variable speed drive system allows the operator to fine-tune the blade speed fast and easily * Exclusive 6 contact point blade adjustable guide assemblies * Mitering Head - the workpiece remains fixed while the head swivels to cut any angle 0°- 45° * Heavy duty transmission utilizes hardened and ground gears operating in and oil bath * Counterbalanaced feed system is controlled by a dual system of counterbalance springs working with a hydraulic cylinder * Exclusively PATENTED 3 jaw vise allows for faster set-up * Recirculating coolant system standard ,1 GPM pump, 8 gallon reservoir and coolant applied through the blade guides 70 to 190 Feet per minute - Variable speed Recirculating system standard with each machine complete with 1 GPM pump, 8 gallon reservoir and coolant applied through the blade guides |