Up
|
For More information on this item, contact us at: Hypertherm PowerMax 1000 Plasma Cutter Recommended capacity: metals to 3/4 inch (19 mm) at cutting speeds over 20 inches (500 mm) per minute. 1 inch (25 mm) at cutting speeds over 10 inches (250 mm) per minute. Severance capacity: rough cut on metals up to 1 1/4 inches (32 mm) at 60-amp, 8.4-kilowatt output provides ample power for clean, quick cutting. Auto-voltage runs on voltages from 200 to 600 volts, 1- or 3-phase, (CE 230 to 400 V 3-phase only) without the need for manual rewiring. New Boost Conditioner circuit compensates for input voltage variation. Advanced, digitally-controlled inverter design delivers continuously adjustable, constant current output, from 20 to 60 amps, permitting high-quality cuts over a wide range of metal thicknesses. An active electronic pilot arc controller for cutting expanded metal or grating. New gouging setting allows for improved arc transfer, easier operation and faster is standard on all units, allowing automated control and rapid change Construction and structural fabrication *Travel speeds are approximately 80% of maximum. 200 – 600 V, 1/3-PH, 50 – 60 Hz, CSA 230 – 400 V, 3-PH, 50 – 60 Hz, CE 200/208/230/240/480 V, 1-PH: 50/48/44/42/22 A 200/208/230/240/400/480/600 V, 3-PH: 30/29/26/24/15/12/11 A Output Current Adjustable, 30-80 A 50% @ 60 A, 230 – 600 V, 3-PH 50% @ 60 A, 230 – 480 V, 1-PH 40% @ 60 A, 200 – 208 V, 3-PH 40% @ 60 A, 200 – 208 V, 3-PH 23.1" (586 mm) D; 10.7" (271 mm) W; Weight with Torch 83 lbs (37 kg) Gas Supply Clean, dry, oil-free air Flow Rate 400 scfh; 6.7 cfm (189 l/min) at 90 psi (6.2 bar) 70 psi (4.8 bar) flowing, 25' leads 75 psi (5.1 bar) flowing, 50' leads If you have questions, call . Information about our company is also available on our website. |