Up
|
MCK2812 DSP Motion Control Kit MTK2812 DSP Motion Control Kit MCK2812 DSP Motion Control Kit is designed for high performance Digital Motion Control system and based on Texas Instruments TMS320F2812 DSP. It is a reliable and fast servomotor driver solution, which contains three parts: MCK2812 DSP Board, PM50 Power Module and IB-2812 Interface Board. MCK2812 DSP Motion Control Kit can directly connect with one or two DC brush/brushless servomotors, AC asynchronous motors, AC permanent-magnet synchronous servomotor and stepper motor to form a digital servo motion control system. Ø Digital motor control (DC brush/brushless servo motor, stepping servo motor, AC servo motor) Ø VFC (Variable Frequency Control) Ø Digital control machine-tool Ø DSP controller TMS320F2812 operating at 150 MHz Ø 128K word on-chip Flash program memory Ø 18K word on-chip data/program of RAM memory Ø 128K word on-board data/program of RAM memory Ø RS-232 serial communication port Ø Opto - isolated CAN communication interface Ø Standard I/O connector (3.3V – MC-BUS) for simultaneous links with two power modules Ø Access to 56 Individually Programmable GPIO DSP pins Ø 16 channels of 12-bit accuracy A/D inputs Ø DSP address / data expansion bus connector Ø Single DC power supply: +5V or +24V IB-2812 Interface Board Features: Ø To evaluate the extended keyboard interface and display panel interface of TMS320F2812DSP chipset Ø Able to operate with MCK2812 via MCBUS Ø 6 channels of PWM output (PWM1-6 if goes to MCBUS of Event Manager A, PWM7-12 if goes to MCBUS of Event Manager B) Ø 6 I/O of I/O PORTB to press keys and LEDs Ø 8 channels of AD input either AD0-7 or AD8-15 Ø Special purpose chip with SPI interface to administer the nixie tube and press keys Ø Power supplied by MCK2812 board Ø Power supply: 12~40DC, maximum peak value current 10A, output power up to 50W, alternative driver module output power up to 400W Ø With over-current, over-voltage, under-voltage and over-heat protections, PWM frequency up to 40KHz Ø Input interface for incremental photoelectric encoder signal and Hall sensor signal Ø May connect with DC brush/brushless servomotor, AC asynchronous motor, AC permanent-magnet synchronous servomotor and stepper motor to form a digital servo motion control system when operating along with MCK 2812 Board Ø 1x Brushless motor with Hall sensors and 500-line encoder |