Harrison13 In Tool Room Engine Lathe SPECIFICATIONS: SWING OVER BED ............................ 13 " SWING OVER CROSS SLIDE .................... 8-1/2" DISTANCE BETWEEN CENTERS ..................40 HOLE THROUGH SPINDLE ...................... 1.625 INCH SPINDLE NOSE ............... L0 NPSE SPINDLE SPEEDS ........: 35 TO750 RPM OR 59 TO 1250 RPM THREADS, INCH ........................ 4 TO 60 T.P.i. (built-in metric-conversion cluster which enabled a range of 11 metric pitches) POWER FEEDS.................. 0.0017" to 0.025" PER iNCH HEADSTOCK & TAILSTOCK SPINDLE CENTER TAPER #3 MORSE TAILSTOCK SPINDLE DIAMETER ................ 1-1/4" TAILSTOCK SPINDLE TRAVEL .................. 4-1/2" 8" (203 mm) deep induction-hardened bed APPROXIMATE WEIGHT ........................ 2000 LBS. APPROXIMATE FLOOR SPACE ................... 61" x 30" INSPECT UNDER POWER IN OUR SC WAREHOUSE BY APPOINTMENT Small Foot Print floor area of only 29" x 60" 13 " swing by 40" Centers - 2 Hp Motor Freshly Updated - HITACHI Variable Frequency Drive Controller Updated Clutched and braked all-geared headstock Built-in metric-conversion cluster which enabled a range of 11 metric pitches 36 SAE Inch threads and feeds from 4 to 60 tpi - 2 HORSE POWER MAIN DRIVE MOTOR FOR 220 VOLT 1 PHASE OPERATION For history and Info on 13 Inch Harrisonmodel look here http://www.lathes.co.uk/harrison/page11.html by calling Cell ___________________________________________________________________________________________________________________ We Stock: Surplus and Used Machinery, _____________________________________________________________________________________________________ Visit our new warehouse in Ridge Spring South Carolina Exit 22 off I-20 _____________________________________________________________________________________________________ Call Us @ ..9- 5 EST Serving Industry and Gear Heads Since 1958 _____________________________________________________________________________________________________ |