Up
|
THIS SYSTEM HAS HAD ONE OWNER AND IS IN VERY GOOD CONDITION (SYSTEM CAN FIT ON A PALLET AND WEIGHS APPROX 150 LBS) * When you need a lot of foam, or a system that can stand up to continuous use, you need the GHC-220. It's built to take the constant demands of an assembly line setup, or to fill the largest containers. With over three times the heating power of the GHC-110, you don't have to worry about temperature recovery times while dispensing. * E-Z Flow now offers a low pressure Spray System, which will enable casual users to apply spray foams without the expense and inconvenience of bulky and high priced special equipment. Offered with the same Electronic Controller and 20-ft hoses as our standard pour equipment, and using an adaptation of our standard Dispensing Gun, the LPS System offers an economical alternative to equipment costing three times as much! This is our 110 Volt Controller Unit, as described above (220 Volt is also available, as noted under our GHC-220 System above). The enclosure measures approx. 11" wide, 13" high, and 7" deep. It's flanged for convenient mounting. Color-coded 8-ft leads are provided for the hose heater blocks (see below), and a 10-ft power cord is attached. 220V units has L6-30 plugs. The Controller allows precise temperature settings for each heated hose independently. Circuit protection is also independent for both hoses. E-Z Flow's factory temperature settings are 135° F for the "A" hose, and 155° F for the "B" hose. These are easily changed in the field, with the programming information provided with the unit, but not to exceed 170° F. Other settings are programmed by E-Z Flow, and we recommend consulting with us before attempting to make any changes. The Heater Assemblies are unique in the industry. By placing the heating units inside the hoses, we allow much better control of temperature, and less power is needed to maintain the same temperature vs. external heaters. Hose assemblies are 20 feet long, which allows operators substantial freedom to move around while using the equipment. The hose assemblies' braided stainless steel outer covering provides maximum protection, flexibility, and durability. The "A" and "B" hoses are clearly marked, and are color coded red and blue to match the leads from the controller. We are especially proud of the E-Z Flow Dispensing Gun. This unique design provides a comfortable, ergonomically designed grip, and controls that are easy to understand and use. The gun is light, well balanced, and easy to point and control. Routine care and maintenance are also designed to be quick, simple, and safe. The gun is actuated by compressed air at 100-120 PSI, as are the Drum Pumps. The system requires about 2 CFM of compressed air in continuous use. Drum Pumps and Accessories As part of our turnkey package, E-Z Flow offers a set of two IPM stainless steel pneumatic Drum Pumps, with pressure relief valves. These are a recognized industry standard pump, and will operate with any standard polyurethane compounds, in 55-gallon drums. We also offer a full line of accessories, including a "holster" stand for the Dispensing Gun, which includes a cleaning brush and solvent tray; a hose hanger, to keep the hoses up away from the working area and allow easier operation; and other useful accessories. |
