Up
|
DENNISON MODEL WRO65LC204FSD HYDRAULIC GAP FRAME PRESS* Capacity: 6 Ton Stroke: 12" (Maximum) Daylight: 16" Cylinder Bore: 3-1/4" Ram Diameter: 2-1/4" Throat Depth: 7-1/2" Table Area: 18" L-R x 11-1/2" F-B "U" Slot Opening in Bed: 5" W x 8" D Bed Height From Floor: 36" Speeds: 185 IPM - Advance 185 IPM - Press 440 IPM - Return Maximum PSI: 1450 Welded All Steel Frame EQUIPPED WITH: Inching Control Non-Rotating Ram Guide Stroke Limit Collars Pressure Adjustment with Gauge Bolster Plate (1" Thick) 5 HP AC Main (Pump) Drive Motor Electrical Controls Dual Lever Operation 10 Gallon Reservoir Capacity; Sight Type Oil Level Gauge Mounted on Factory Base Approximate Overall Dimensions: 34" L-R x 29" F-B x 82" H Approximate Weight: 1,300 Lbs. Serial Number: 23597 (New 1974) P2 F.O.B. Elk Grove, IL - $ 4,750.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |