Up
|
DAITO MODEL GA400 FULLY AUTOMATIC, PROGRAMMABLE, HORIZONTAL BAND SAW* Capacity: 15-3/4" x 15-3/4" Blade Length: 15' Blade Width/Gauge: 1-1/4" x .042" Blade Speeds (Variable): 66 - 525 FPM Indexing Stroke (Variable): 16" to 39'9-3/4" Maximum Load on Index Saddle: 8,800 Lbs. Table Height from Floor: 28" Cast Iron Frame EQUIPPED WITH: CRT Controller (Recommends Cutting Conditions, Compares Actual & Recommended Cutting Rates, 24 Different Lengths & Numbers of Pieces Can be Programmed at the Same Time) Automatic Indexing of Up to 5 Different Lengths in One Set-Up Hydraulic Clamping Variable Feed and Speed Control Chip Conveyor 7 HP AC Main Drive Motor 2 HP AC Hydraulic (Pump) Drive Motor 1/12 HP AC Coolant Pump Motor Electrical Controls Approximate Overall Dimensions: 95" L-R x 76" F-B x 60" H Approximate Weight: 6,000 Lbs. Serial Number: (New 1992) P2 F.O.B. Elk Grove, IL - $ 9,500.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |