Up
|
CHIYODA MODEL SP-90ST CNC, HYDRAULIC ROTARY TUBE BENDER* Maximum Bend Radius: 13.8" Maximum Tube Length Over Mandrel: 157.6" Maximum Degree of Bend: 0 - 190 Degrees Productivity (Bends/Hour): 450 - 300 Speeds: Bend (Degrees/Sec): 6 - 30 Plane (Degrees/Sec): 18 - 90 Feed (Inches/Sec): 3.94 - 15.76 IPS Repeatability: Bend and Plane: +/- 0.05 Degrees; Feed: +/- 0.0039" Process Number: 0 - 30; Number of Control Axes: 3 Clockwise Rotation EQUIPPED WITH: Type II 3-Axis CNC Control Multi-Radius Bending Option Automatic Hydraulic Mandrel Extractor Motorized Carriage for Plane of Bend and Distance Between Bends Collet Device for Carriage Direct Acting Pressure Die; Pressure Die Assist Drop Away Clamp Die; Overhead Tie Bar Clamp, Pressure and Wiper Die Holders Mandrel Lube; Swinging Arm Safety Device; Water Cooled Heat Exchanger 40 HP AC Main Drive Motor; Electrical Controls Seperate, Free-Standing Operator Control Console BENDING CAPACITIES (MILD STEEL): Pipe: 4.5" O.D. x .177" Wall or 3.5" O.D. x .276" Wall Bar (Round): 1.97" Approximate Overall Dimensions: 300" L-R x 85" F-B x 82" H Approximate Weight: 15,000 Lbs. Serial Number: 1992-7-10 (New 1992) P2 F.O.B. Elk Grove, IL - $165,000.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |