Up
|
BERTSCH MODEL 22 15' x 1-5/8" PLATE BENDING ROLL* Capacity: 15' x 1-5/8" (Mild Steel) Diameter of Top Roll: 19" Diameter of Bottom Rolls: 24" Power Adjustment to Lower Front Roll (for Plate Thickness) Power Adjustment to Lower Rear Roll (for Bending Diameter) Fabricated Steel Base EQUIPPED WITH: Initial Pinch Set up Hydraulic Drop End Housing Hydraulic Adjustment to Top Roll (3) 25 HP AC Limit Torque Roll Adjustment Motors Lower Roll Digital Position Indicators Automatic Lubrication System Power Tilt 75 HP AC Main Drive Motor; 50 HP AC Rear Roll Adjustment Motor Electrical Controls Cabinet Mounted Operator Control Station 15' Wide x 11' Long Plate Loading Conveyor Approximate Overall Dimensions: 360" L-R x 200" F-B x 84" H Approximate Weight: 150,000 Lbs.(ROLLS WEIGH ABOUT 24K EACH) Serial Number: M-10708 (New 1985) * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |