12" x 24" KENT Hydraulic Surface Grinder, Model KGS-63SD1, S/N 97106405 (New December 1997) Overall table working area (width x length) Maximum table load (with chuck) Maximum/Minimum distance between working table Cross feed handwheel is graduated in increments of Automatic cross feed per stroke of table Downfeed handwheel is graduated in increments of Downfeed travel per revolution of handwheel Hydraulically actuated longitudinal feed Electromechanically actuated cross feed Automatic incremental downfeed of grinding wheelhead driven by stepping motor Programmable logic controller (PLC) of all machine functions including: "Rough Downfeed" increment and number of passes, "Fine Downfeed" increment and number of passes, "Sparkout" times, "Downfeed Mode" for control of incremental downfeed with table at right end of stroke, left end of stroke, or both left and right end of stroke, "Wheelhead Elevation & Position" for control of elevation increment at completion of grinding job, "Jog" increment to allow the operator to select three different jog rates of the grinding wheelhead, and "Reset" to set the current position of the grinding wheel as 0 point The PLC has a LED display to show the position of the grinding wheel in relation to the starting point. Selector switch for surface or plunge grinding modes of operation Selector switch for automatic incremental downfeed, downward jogging, or power rapid elevation of grinding wheelhead 12" x 23-5/8" Fine division electromagntetic chuck with console mounted controls including: variable magnetic strength, magnetization/demagnetization mode selector, and voltage gauge meter Over-the-wheel parallel dresser External hydraulic pump and tank External coolant pump and tank with paper band filtration 5 H.P. 3/60/575 volt spindle drive motor with electrical transformer for 3/60/220 Parts and service available from the KENT Industrial (USA) Inc at Approximate Floor Space Required: (F.O.B. Truck, Hauppauge - Long Island, NY) |