Up
|
CARLTON MODEL 0A RADIAL DRILL* Column Diameter: 9" Face of Column to Center of Spindle: 9"(Minimum) 36"(Maximum) Spindle Radius: 16" to 3'7" Spindle to Base: 16" to 4'5" Swing of Arm: 52" Vertical Travel of Spindle in Head: 10" Traverse of Head on Arm: 2'3" Spindle Diameter: 2.5" Spindle Speeds: (9) 80-2000 RPM Spindle Taper: #4 Morse Spindle Motor: 5HP Spindle Feeds: (6) 4-25 IPR EQUIPPED WITH: Box Table Coolant Pump 440V 3 Phase Electrical Power Elevation Approximate Overall Dimensions: Approximate Weight: Serial Number: OA1123 (New 1967) * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |