ARONSON MODEL G600 45/90 GEAR-DRIVEN WELDING POSITIONER* Capacity: 60,000 Lbs. with CG 12" Overhang and 12" Eccentric Table Size: 96" Square with 8-Radial Slots Table Rotation Speed (Variable): .01 - .41 RPM Power Forward Tilt: 90 Degrees in 64 Seconds Inherent Overhang: 9" Flat Table Height: 81" Maximum Load Torque: 720,000 Lb. In. - Rotation 1,260,000 Lb. In. - Tilt EQUIPPED WITH: 90 Degree Forward Tilt/45 Degree Back Tilt Hollow Spindle Design Electrical Vari-Speed Drive Main Drive (Rotation) Motor 7-1/2 HP AC (Tilt) Brake Motor Electrical Controls Remote Pendant Push Button Operation Approximate Overall Dimensions: 125" L-R x 125" F-B x 85" H Approximate Weight: 17,000 Lbs. Serial Number: 6912 (New 1969) P2 F.O.B. Elk Grove, IL - $ 44,500.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |