Up
|
WALLACE MODEL 604 HYDRAULIC TUBE BENDER* Maximum Radius: 30" Maximum Bend Angle: 90 Degrees Height from Floor to Centerline of Bending Form: 42" EQUIPPED WITH: Dual Cylinder w/Roller Chain Drive System Manual, Screw-Type Pressure Die 5 HP AC Main Drive (Pump) Motor Misc. Tooling BENDING CAPACITIES: I.P.S. Extra Heavy Pipe: 4" (Schedule 80) Non-Ferrous Tubing Y.P. to 25,000 PSI: 5-1/4" O.D. x .125" Wall Square Tubing Mild Steel: 4" x .375" Wall Steel Bar Y.P. to 40,000 PSI: 1" x 12" Flat Bar Bus Copper: 1-1/2" x 10" Approximate Overall Dimensions: Approximate Weight: Serial Number: 7316 P2 F.O.B. Lester, PA - $ 17,500.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |