Up
|
VULCAN MODEL SHIMMY 1" HYDRAULIC DOUBLE END TUBE CUTOFF* \ Capacity (Mild Steel): 1" O.D. x .020" Wall (Maximum) Standard Cut Lengths: 1/4" to 48" (Longer if Needed & Equipped) Working Height: 40" Cut Length Tolerances: in Thousandths of an Inch Commercially Burr Free with Little or No Distortion Maximum Operating Pressure: 1650 PSI EQUIPPED WITH: Allen-Bradley Micrologic-1500 PLC (2) Pedestal Pushbutton Controls w/Quick Panel jr. (2) Trabon Automatic Lube Systems (2) 25 HP AC Main (Pump) Drive Motor (2) Electrical Controls (2) Pabco Hydraulic Power Units Koolant Koolers - Oil Chiller *** CAN BE USED AS TWO SEPARATE SINGLE END TRIMMERS OR DOUBLE END TUBE CUT-OFF ***** Approximate Overall Dimensions: 165" L-R x 50" F-B x 80" H Approximate Weight: 10,000 Lbs.((2)HYDR.80"X 40"X 73"H) (CHILLER:42"X 30"X 66"H) Serial Number: 18277 (New 2002) P2 F.O.B. Elk Grove, IL - $ 99,500.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |