Up
|
OKUMA MODEL GI-20N CNC INTERNAL GRINDER* Swing over Table: 19.69" Maximum Work Length: 7.87" Wheel Infeed Slide (X-Axis)Travel: 7.98" X-Axis Feed Rates: .0008-.4 IPM X-Axis Rapid Rate: 472.44 IPM Table (Z-Axis)Travel: 19.69" Z-Axis Feed Rate: 236.22 IPM Z-Axis Positioning Rate: 472.44 IPM Workhead Spindle Bore: 2.76" Workhead Spindle Nose Diameter: 3.94" Workhead Spindle Speeds: 100-750 RPM Workhead Angle of Swivel: 10 Degrees EQUIPPED WITH: Fischer MFV 1430 30,000 RPM Grinding Spindle 10" Diaphram Chuck Volkman 9000 Tool Pressure Sensor Coolant Approximate Overall Dimensions: Approximate Weight: Serial Number: 0405-0303 (New 1992) * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |