New hypertherm powermax 1250 plasma cutter

UpUp


Subject: New hypertherm powermax 1250 plasma cutter
For More information on this item, contact us at:
Hypertherm PowerMax 1250 Plasma Cutter
The Powermax1250 is the first of the
Powermax G3 Series. With new technologies
in both power supply and torch, it cuts faster
and more economically than any system
available today. In fact, it cuts 80% faster on
1-inch (25 mm) mild steel than any competitor tested. Its Auto-voltageâ„¢ circuit provides automatic adjustment to any input voltage from 200 to 600 volts, 1- or 3-phase. A state-of-the-art, microprocessor-based architecture assures optimum system
Recommended capacity: metals to
7/8 inch (22 mm) at cutting speeds
over 20 inches (500 mm) per minute.
1 1/8 inch (29 mm) at cutting speeds
over 10 inches (250 mm) per minute.
Severance capacity: rough cut on
metals up to 1 1/2 inches (38 mm) at
Advanced, intelligent technology gives the
Powermax1250 the power to cut with greater
speed, quality and efficiency.
80-amp, 12-kilowatt output provides
ample power for clean, quick cutting.
Auto-voltage runs on voltages from
200 to 600 volts, 1- or 3-phase, without
New Boost Conditionerâ„¢ circuit
compensates for input voltage variation.
Advanced, digitally-controlled inverter
design delivers continuously adjustable,
constant current output, from 25 to
80 amps, permitting high-quality cuts
over a wide range of metal thicknesses.
An active electronic pilot arc controller
for cutting expanded metal or grating.
New gouging setting allows for improved
arc transfer, easier operation and faster
is standard on all units, allowing
automated control and rapid change
Construction and structural fabrication
Work cable with clamp15 feet (4.5 m)
*Maximum travel speeds are the results of Hypertherm's laboratory testing. For optimum cut quality, speeds should be reduced between 35 50%, depending upon the material. Refer to your operators manual for more detail.
200 600 V, 1- or 3-PH, 50/60 Hz, CSA
230 400 V, 3-PH, 50/60 Hz, CE
200/208/230/240/480 V, 1-PH: 70/70/60/58/31 A 200/208/230/240/400/480/600 V, 3-PH: 41/40/37/34/21/17/17 A
Output Current Adjustable, 25 to 80 amps
60% @ 80 A, 230 600 V, 3-PH
50% @ 80 A, 200 208 V, 3-PH
40% @ 80 A, 200 208 V, 1-PH
23.1" (586 mm) D; 10.65" (271 mm) W;
Weight with Torch 96.6 lbs (44 kg)
Gas Supply Clean, dry, oil-free air
Flow Rate 400 scfh; 6.7 cfm (189 l/min) at 90 psi (6.2 bar)
70 psi (4.8 bar) flowing, 25' leads
75 psi (5.1 bar) flowing, 50' leads
If you have questions, call . Information about our company is also available on our website.
Try Andale Gallery. Now with Brand New Themes.