Up
|
HAEUSLER MODEL HPR 18 HYDRAULIC, VERTICAL/HORIZONTAL ANGLE BENDING ROLL * Speeds: 11.5 and 21 FPM (3) Roll (Hydraulic) Drive EQUIPPED WITH: (1) Set of Rolls; (1) Set of Adjustable Guide Rolls Hydraulic Adjust to Lower/Side Rolls AC Main (Pump) Drive Motor; Electrical Controls Operator Control Station; Hydraulic Power Unit (Separate) CAPACITIES: MILD STEEL (YP 34,000 PSI/Tensile Strength 64,000 PSI) 7.1" x 7.1" x .71" Angles - Leg Out (Max) to 95" Minimum Diameter 2.8" x 2.8" x .47" Angles - Leg Out (Min) to 32" Minimum Diameter 6.3" x 6.3" x .79" Angles - Leg In (Max) to 98" Minimum Diameter 2.8" x 2.8" x .47" Angles - Leg In (Min) to 39" Minimum Diameter Squares: 3.7" x 3.7" to 37" Minimum Diameter Round Bar: 4.3" Diameter to 43" Minimum Diameter Pipe: 7.5" x .22" to 79" Minimum Diameter Tees - Web Out: 4.9" x 4.9" x .75" to 87" Minimum Diameter Tees - Web In: 6.3" x 6.3" x .79" to 98" Minimum Diameter Beams on Flanges: NP 36 to 79" Minimum Diameter Beams Around X-Axis: NP 16 to 197" Minimum Diameter Channels - Flanges Out: NP 38 to 87" Minimum Diameter Channels - Flanges In: NP 38 to 87" Minimum Diameter Approximate Overall Dimensions: 201" L-R x 110" F-B x 93" H Approximate Weight: 51,000 Lbs. Serial Number: 1309 (New 1972) P2 F.O.B. Varnamo,Sweden - $ 59,500.00 * PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION Email us at Call our Sales Staff at Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes. Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power. (outside US & Canada) Email: |