Up
|
Provide fresh heated air to your Restaurant, Warehouse, Paint Booth, Factory, etc. F3-D.750-G18 Direct Gas Fired Heated Make Up Air Unit with 18" Blower and 18" Burner. Supply Fan handles 5500 CFM @ 0.375" wc. Fan runs at 657 RPM. Supply Motor: 3.000 HP, 3 Phase 208 V, 9.5 FLA, ODP (Open Drip Proof) - Sloped Filtered Intake for Size #3 Modular Heater. 37.25" Wide X 51.625" Long X 35.188" High. Includes 2" MV EZ Kleen Metal Mesh FIlter Maxitrol 14 • 40-80°F Discharge Temp Control Order # 382641 - Quote #382641 Fan #2 F3-D.750-G18 ( 930.96 lbs. ) Direct Gas Fired Heated Make Up Air Unit with 18" Blower and 18" Burner. Model 00318OS3EF56Z-40PP, 3 HP, 3 Phs, 208 V, 9.5 FLA, ODP (Open Drip Proof) Direct-fired burner assembly. 825,000 BTU/HR Maximum, 27,500 BTU/HR Minimum. 18" long. Used in size 2 and 3 modular and standard direct-fired heater. Used for both Natural and Propane Gas. Pilot/Flame Rod/Spark Assembly included. Pre-wired, pre-piped controls. 120 volt control transformer with single point electrical connection. Intermittent spark pilot with timed safety lockout. High temperature limit switch. Please send zip code for a freight quote. * Housing constructed of heavy duty G90 galvanized steel * Forward curved centrifugal blower wheel * Adjustable drive assemblies * Heavy duty, pre-lubricated bearings rated for 200,000 hours of operation * Service doors on both sides * Horizontal & down discharge * Large intake area ensures low pressure drop across unit * Spring loaded profile plates automatically adjust for any airflow - no manual setting required! * Weatherproof safety disconnect switch * Modular design provides design flexibility 18" forward curved, centrifugal blower. Permanently lubricated ball bearings. Galvanized finish. 4000-12000 CFM. 1-3/16" x 30-3/4" Shaft. 1450 max. RPM. Used in heated and non-heated supply fans. Maxitrol 14 • 40-80°F Discharge Temp Control Sloped Filtered Intake for Size #3 Modular Heater. 37.25" Wide X 51.625" Long X 35.188" High. Includes 2" MV EZ Kleen Metal Mesh FIlter. 6x MV EZ Kleen Metal Mesh Filter. 16"x 20"x 2" Used for heater and supply fan intakes. (3412) OPERATION & INSTALLATION MANUALS Comprehensive Supply Fan Information Operation and Installation Manual (PDF) The FD Model has been certified by ITS. This certification mark indicates that the product has been tested to and has met the minimum requirements of a widely recognized (consensus) U.S. and Canadian products safety standard, that the manufacturing site has been audited, and that the applicant has agreed to a program of periodic factory follow-up inspections to verify continued performance. Model FD is ETL Listed under file number J20042560-001 and complies with ANSI Z83.4a-2001 Standards and CSA 3.7a-M99 Standards. |