Eagle i/o i/o hydraulic tube end former

UpUp


Subject: Eagle i/o i/o hydraulic tube end former
EAGLE MODEL I/O-I/O "LONG" SPECIAL CNC HYDRAULIC TUBE END FORMER*
Capacity: 3" O.D. (Max.)
1-1/4" O.D. (Min.)
Lenght of Tube: 9-1/4"
Ram Travel (Maximum): 4"
Average Cycle Time: 2 Sec.
Capabilities: Expanding, Reducing, Sizing (of two different
diameters), Beading, Flaring & Embossing
EQUIPPED WITH:
Xycom CNC Control w/CRT (Overarm Mounted)
(2) Forming Heads (Longitudinally Mounted on Common "Long"
Base & Facing Each Other)
Automatic Tube Loader (for up to 9-1/4" Long Tubes)
Finished Tubes Shute
Trabon Automatic Lubrication System
(2 ea.) Self-Contained Hydraulic Power Units
(2 ea.) 15 HP AC Main (Pump) Motors Currently 460
Electrical Controls
Approximate Overall Dimensions: 185" L-R x 72" F-B x 85" H
Approximate Weight: 10,000 Lbs.
Serial Number: 93-760 (New 1993)
P2 F.O.B. Elk Grove, IL - $ 24,500.00
* PRELIMINARY SPECIFICATIONS SUBJECT TO VERIFICATION
Email us at
Call our Sales Staff at
Prices do not include any federal, state or local taxes, which are in addition to the purchase price and must be paid by the Purchaser. Any and all foreign duties and taxes are the responsibility of Purchaser. Unless Purchaser furnishes PMS with a tax exemption certificate, any sales, use, excise, or other similar tax, where applicable, shall also be the responsibility of Purchaser and may, at the election of PMS, be added to the quoted purchase price and invoiced by PMS to Purchaser. The failure of PMS to invoice such taxes does not excuse the Purchaser from responsibility for paying necessary taxes.
Some machinery and equipment is located at Fortune 100 Manufacturing Facilities. Most of the machinery and equipment located at these Facilities is disconnected and cannot be seen under power. Unless specifically listed in writing by PMS, all machinery and equipment uses 3 Phase power.
(outside US & Canada)
Email: