Up
|
Provide fresh heated air to your Restaurant, Warehouse, Paint Booth, Factory, etc. F5-D.2000-925 Direct Gas Fired Heated Make Up Air Unit with 25" Blower and 48" Burner Supply Fan handles 15000 CFM @ 0.500" wc. Fan runs at 594 RPM. Supply Motor: 10.000 HP, 3 Phase 208 V, 27.9 FLA, ODP (Open Drip Proof) - Sloped Filtered Intake for Size #4 Modular Direct Fired Make-Up Air Units. 45.81" Wide x 70.05" Long x 44.00" High. Includes 2" MV EZ Kleen Metal Mesh FIlter. - Maxitrol 14 • 40-80°F Discharge Temp Control Fan #4 F5-D.2000-925 ( 2038.51 lbs. ) Direct Gas Fired Heated Make Up Air Unit with 25" Blower and 48" Burner Model 01018OP3E215T, 10 HP, 3 Phs, 208 V, 27.9 FLA, ODP (Open Drip Proof) Direct-fired burner assembly. 2,200,000 BTU/HR Maximum, 73,333 BTU/HR Minimum. 48" long-"H" Shaped. Used in size 5 modular and standard direct-fired heater. Used for both Natural and Propane Gas. Pilot/Flame Rod/Spark Assembly included. 25" forward curved, centrifugal blower. Permanently lubricated pillow block ball bearings. Enamel finish. 10000-25000 CFM. 2 3/16" x 50-1/4" Shaft. 950 maximum RPM. Heavy duty angle iron frame. Used in heated and non-heated supply fans. Maxitrol 14 • 40-80°F Discharge Temp Control Sloped Filtered Intake for Size #5 Modular Heater. 55.81" Wide X 70.05" Long X 51.00" High. Includes 2" MV EZ Kleen Metal Mesh FIlter. 8x MV EZ Kleen Metal Mesh Filter. 20"x 25"x 2" Used for heater and supply fan intakes. (3416) Pre-wired, pre-piped controls. 120 volt control transformer with single point electrical connection. Intermittent spark pilot with timed safety lockout. High temperature limit switch. Please send zip code for freight quote OPERATION & INSTALLATION MANUALS Comprehensive Supply Fan Information Operation and Installation Manual (PDF) The FD Model has been certified by ITS. This certification mark indicates that the product has been tested to and has met the minimum requirements of a widely recognized (consensus) U.S. and Canadian products safety standard, that the manufacturing site has been audited, and that the applicant has agreed to a program of periodic factory follow-up inspections to verify continued performance. Model FD is ETL Listed under file number J20042560-001 and complies with ANSI Z83.4a-2001 Standards and CSA 3.7a-M99 Standards. |